From: Keilbach, Robert [Robert.Keilbach@wgint.com]
Sent: Wednesday, February 01, 2006 8:33 PM
To: Thomas G. Brown
Subject: RE: Review SXR drawing

Tom,
Please note the following comments:
 
Sheet 1 of 2: 
Note 1 should be revised to read as follows:
Welding shall be performed in accordance with the requirements of ASME B31.3 and PPPL Procedure ENG-037. Visual weld inspection shall be performed in accordance with the acceptance criteria of ASME B31.3 Category D.
 
Sheet 2 of 2:
1. Delete ...."or GMAW" - 3 places
2. Delete the circle "weld-all-around" symbol from the outside 1/8" intermittent fillet welds - 1 place.
3. The specified 1.5" length intermittent fillet welds at 45 degree intervals (8 total weld increments) are excessive for welding around a 3.5" diameter mounting cup. 
 
Please call me at 718 3588568 if there are any questions.
 
Bob

________________________________

From: Thomas G. Brown [mailto:tbrown@pppl.gov]
Sent: Wed 2/1/2006 9:33 AM
To: Keilbach, Robert
Subject: Review SXR drawing


Bob,
 
I've attached the soft X-ray diagnostic drawing for your weld inspection.  The job charge is: 9450 3*** 3101
 
Thanks,
Tom
 
 
 
 
Tom Brown
Princeton Plasma Physics Lab
PO Box 451
Princeton, NJ 08543-0451
 
Phone: (609) 243-2156       fax: (609) 243-3030