From: Steve Raftopoulos
Sent: Tuesday, October 17, 2006 3:35 PM
To: Michael E. Viola; Thomas G. Brown
Cc: Arthur W. Brooks; Bob Simmons; Bradley E. Nelson; Edward G. Bush;
Hutch Neilson; John W. Edwards; Lawrence E. Dudek; Michael C.
Zarnstorff; Michael J. Duco; Mike Cole; Paul Goranson; Ronald L.
Strykowsky; Thomas G. Brown; Wayne T. Reiersen
Subject: Re: VVSA acceptance and baseline files



Mike,

I don't believe that Tom has all the final data files yet: 

*	I just got the VVSA3 data yesterday from Mike D. and have not finished with the best fit 
*	The VVSA Spool Piece_2 data that Mike D.sent to Tom were preliminary data that had not been best fit. 

I'm working with the raw data and should have the rest of the best fit data for Tom this week.


Steve


At 02:58 PM 10/17/2006, Michael E. Viola wrote:


	Tom,
	I believe these files represent the completed in house verification:
	VVSA #1, #2, and #3; VVSA spool pieces #1, #2, and #3.
	We have accepted Major Tools scan but they were self generated without
	any independent check.
	Our in house scans represent an independent check.
	
	Please provide an acceptance statement of each or all of the VVSA parts.
	
	I should remind you that the port 4 and port 12 surfaces are bowed and
	out of tolerance per the Major Tool scans and associated NCR's and are
	not part of these scans nor do I plan to have them done unless you
	require it.  
	
	I would also ask you to file these files with the other files in your
	metrology folder since they form the baseline file set for machine
	assembly.
	
	Thanks,
	
	Mike Viola, PPPL, (609) 243 3655
	
	
	-----Original Message-----
	From: Steve Raftopoulos 
	Sent: Tuesday, October 17, 2006 1:26 PM
	To: mviola
	Cc: tbrown; Mike Cole; Arthur W. Brooks
	Subject: VVSA_Spool piece_3 measurement Reports
	
	Mike,
	
	here are the VVSA_Spool_Piece_3 inspection reports generated from the 
	measurements done here at PPPL.  The spool piece was best fit using
	points 
	from the outer shell , tube and flange inner facing surface(s).  The 
	remaining measurement data was not included in the best fit, but did
	move 
	with the translation matrix.
	
	If needed, we can generate additional reports and /or IGES files of any
	(or 
	all) of the points we measured.
	
	Steve
	
	
	
	Steve Raftopoulos
	Senior Staff Engineer
	Princeton Plasma Physics Laboratory
	P.O. Box 451, Princeton, NJ 08543
	(609) 243-3626 Voice
	(609) 243-3248 Fax 
	
	
	
	
	



Steve Raftopoulos
Senior Staff Engineer
Princeton Plasma Physics Laboratory
P.O. Box 451, Princeton, NJ 08543
(609) 243-3626 Voice
(609) 243-3248 Fax