From: Craig D. Priniski
Sent: Friday, May 09, 2008 10:42 AM
To: Mark Smith
Cc: Thomas G. Brown
Subject: RE: port and clamp data

Attachments: 20080508_HPA1_C_3 PORT- ROMER.csv; 20080508_HPA1_C_3
CLAMPS-ROMER.csv; HPA1-SHELL-PORTS.IGS; HPA1-WINDING_CLAMPS.IGS

See attached, ports are separated by color and include any clamps and tubes that me be an
interference with insulation later. Nose winding clamps are grouped by splines of Red,
Green, or Blue, indicating which coil they are associated with.  Then the points are
yellow for felt covered locations and light blue for bare metal clamps. There are some
areas that were too close to the arm to measure, we need a new mounting scheme to measure 
in the lower middle of A1, if you need more data then is shown let me know and we'll 
figure something out.



ALL DATA TAKEN WITH A 15 mm diameter (.59") PROBE




-----Original Message-----
From: Mark Smith 
Sent: Friday, May 09, 2008 9:40 AM
To: Craig D. Priniski
Cc: Thomas G. Brown
Subject: port and clamp data


Craig,

Can you have the as built clamp and port metrology files complied and sent today?

Mark


Mark Smith
Mechanical Engineer
Princeton Plasma Physics Laboratory 
P.O. Box 451 
Princeton, NJ 08543-0451 
(609) 243-2778