From: Ronald L. Strykowsky
Sent: Monday, June 27, 2005 8:54 AM
To: Bob Simmons
Cc: Wayne T. Reiersen
Subject: RE: ECP-034 - Trinos Flanges and Heat Treating Each WCWF
Casting

There is no reason to process this ECP now. I suggest waiting til the TRC, winding facilities and test stand job are completed and then process a large ECP (my guess is around $800k). Unless there is some other reason to do this I think it makes sense to minimize administrative busy work....(just my two cents)..Ron 

-----Original Message-----
From: Bob Simmons 
Sent: Monday, June 27, 2005 8:42 AM
To: Hutch Neilson; Wayne T. Reiersen; 'Goranson, Paul L.'; David E. Williamson; Phil Heitzenroeder; Judith A. Malsbury; Jerry D. Levine; Larry L. Sutton; Bradley E. Nelson; Ronald L. Strykowsky
Subject: ECP-034 - Trinos Flanges and Heat Treating Each WCWF Casting

Folks,

 

Attached for your review and comment.  

 

Wayne –can you please fill in the rationale for the heat treating of each MCWF casting (stress relief?)?  Since I was out a large part of last week,

I am not current on this.  Trinos Flange is pretty well documented.

 

Ron – any other cats and dogs we want to roll up here?

 

I would like to tentatively schedule at CCB for this on Thursday afternoon.  Say 2:00 pm?

 

Please return comments to me.

 

Thanks,

 

Bob S.

 

Bob Simmons

NCSX Systems Engineering Support Manager

Princeton Plasma Physics Laboratory (PPPL)

Tel #: (609) 243-2766

Fax #: (609) 243-3030